Tutorials
This is one of the cards made for the #2biggirlscraftingretreat.
Cut a piece of A4 in half at 14.85cm. You will only need 1 of the pieces.
SCORE at 10.5cm and fold each side individually to the centre and reinforce the folds.
On the outer 2 score lines, mark 5cm from top and bottom edges on both sides.
SCORE from these points to the nearest corners as in the picture below.
I used my Stampin' Trimmer for my scoring each section.
DECORATE with card. 1st mat
I numbered all of the sections 1-10 except the inner 2.
Panel 1 and 2 in card 14.2cm by 4.7cm
On each strip, the inside edge, mark 4.7cm along the edge at the top and bottom of each piece.
Right hand side of the left piece and left hand side of the right piece. Keep the cut off pieces.
They will look like the sketch below.
Decorate with Designer Series Paper (DSP) 2nd mat.
Cut 2 strips of DSP 13.5cm by 4.5cm. Mark on inner edges of each piece at 4.5cm at top and bottom.
Keep the cut off pieces for the triangles.
In card, cut 2 pieces 4.7cm by 4.7cm and cut diagonally.
In DSP cut 2 pieces 4.5cm by 4.5cm and cut diagonally.
Do not decorate the 2 centre panels. They will be glued or taped together.
Once decorated, tape or glue the 2 centre pieces together, Fold back the triangles at top and bottom.
After decorating the panels, I cut some Stitched Shapes Circles out and stamped a message on.
Please click HERE for more information.
I used the Gingham Gala Designer Series Papers and Butterfly Gala stamp set.
Please click HERE for more information on Gingham Gala DSP
Please click HERE for more information on Butterfly Gala stamp set and punch
Thank you for stopping by.
Gill X
No comments:
Post a Comment